Hose assemblies are special order items and are non-returnable Impulse and burst tested to the highest international hydraulic hose standards. MHSA approved hydraulic hose cover. Designed to be consistently rugged and dependable for the long term. Exceed by 2-1/2 times the abrasion resistance performance specified by ISO 6945 standard. This means increased machine uptime and productivity! Resist ozone damage 5-1/2 times better than the DIN EN 27326 standard. This means maximized hose life. Typical temperature range from -40°F to 212°F Easy to read lay lines Transfer of hydraulic oils and water NPTF (National Pipe Tapered Fuel)The seal is established through the deformation of the threads when the tapered threads of the male are threaded into the female half. "Bite-the-wire" design. The teeth cut through the outer cover and bite into the steel of the hose. One-piece from the connection to the stem. No brazing is involved in the manufacturing process. Burst and impulse tests have been performed to over 1,000,000 cycles. Easily identified. All 'A' Series crimp fittings have a single-line and double-line on their shells Please check out our Hose Assembly Configurator if you do not see the assembly you require here *** Slide left / right to view more ***
